Fenders must be as high as the tallest part of the rear tire and must support the weight of the driver. Fenders and a dead man’s throttle: (Except hand clutch models) are mandatory. SAFETY EQUIPMENT – In DIV’s IV, V and V+ ALL tractors must be equipped with a high back seat measured 7 inches from the base or cushion.Moveable suitcase weights can be used in front of the rear axles and or behind the front axle of the tractor. The wheel weights must be round and made of metal, cast or aluminum materials and be as near appearing to original manufactured weights as possible. Weights of bolt on type to either the front or the back wheels are allowed. “NEW” Division I Weight Rule for 2018 WEIGHTS – Manufactured original factory weights for that make and model are allowed.Rules Wording/Clarifications/Additions, 4-20-18: NOTE: Blocks, heads and or manifolds are NOT allowed to be reproduced using aluminum materials in all Divisions except Division V+. Example: Reproduction blocks, heads and or manifolds are allowed in Divisions: II-TC, III, IV, and V & V+ and NOT allowed in Divisions I and II. ALL replacement parts must meet the current board’s approval. REPLACEMENT PARTS – The term “Replacement Parts” is defined as any part that was available for that tractor make and model of that era, or reproduction parts that duplicate the original part and must be produced and is accessible to purchase by the general public. Example: Reproduction blocks, heads and or manifolds are allowed in Divisions: II-TC, III, IV, and V & V+ and NOT allowed in Divisions I and II.ġ6. Rules Wording/Clarifications/Additions, 9-3-18:ġ6. Copies of the last used Division I and V rules may be obtained by contacting Alison Barber at (641) 295-1760 or As per Board of Trustee decision Divisions I and V are no longer offered Divisions in the NATPA.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |